TM 5-4310-376-14
4-33. CYLINDER HEAD (ENGINE) - Continued
REMARKS
ACTION
LOCATION/lTEM
Cylinder head
a. Remove spark plug (1).
b. Remove 9 bolts (2).
c. Remove cylinder head (3) with cover
(4) and gasket (5).
d. Clean carbon from head, inspect valves
for proper seating. Scrape and brush
head, top of piston and around valves.
Do not tighten one bolt completely before the others, as
it may cause a warped cylinder head.
Cylinder head
a. Assemble cylinder head (2) with a new
head gasket (4), shield (3) and bolts
(1) in their proper position.
b. Grease head bolts (2).
c. Tighten bolts evenly by hand.
See Appendix G for
d. Using a torque wrench, tighten bolts
torque values.
as shown in sequence 1,2,3 etc, to
specified torque.
e. Replace spark plug.
f. Install Starter/Blower housing.
4-73
