TM 5-4310378-14
2 - 9 . OPERATION
pressure gage reading. It should read between 140 and 175 psi (9.8 and 12.3 kg/cm').
As soon as the engine is
the compressor is ready to operate
inflate
If the compressor does
not operate, see TROUBLESHOOTING procedures in Chapter 3 of this manual. Watch for any unusual noise
or vibration.
STOPPING
a. Set speed control lever to idle.
b. Push ignition switch (1) in (STOP)
c. Close fuel tank vent valve.
d. Turn fuel tank valve OFF.
2-11. PREPARATION FOR MOVEMENT
the engine. Close fuel vent valve on fuel cap.
Stop
MOVEMENT TO A NEW WORK SITE
CAUTION
The wheels and axle of the compressor assembly are designed
to move the compressor assembly into position at the worksite.
They are not designed for use during road or highway movement
of the compressor assembly.
a.
a shipping dock or use wood planks as a
ramp to load the compressor assembly on the
I
bed of a suitable truck to transport the
presser assembly.
b. Grasp the handles (1) when moving the
pressor assembly.
c. Secure the compressor assembly to the side of
the truck to prevent it from shifting.
\
.
2-12
Change 1
