TM 5-4310-378-14
a. Removal.
( 1 ) Use7/16-in. and 1/2-in. wrenches and remove two locknuts, two flat` washers, and two
b o l t s from ends of belt guard.
( 2 ) U s e 7 / 1 6 - i n . w r e n c h a n d r e m o v e t w o bolts, two flat washers, and two lock washers
f r o m lower side of belt guard.
( 3 ) U s e 7 / 1 6 - i n . w r e n c h a n d r e m o v e o n e bolt and one lock washer from upper side of belt
(4) Remove belt guard.
Installation.
( 1 ) Obtain serviceable belt guard and locate on the compressor unit.
( 2 ) Start attaching parts, one bolt and one lock washer at upper bracket; two bolts, two
f l a t washers, and two lock washers on lower side; and one bolt, one flat washer, and
o n e locknut on each end of belt guard.
( 3 ) Using 7/16-in. and 1/2-in. wrenches tighten all nuts and bolts equally.