TM 5-4310-378-14
3-14. COMPRESSOR ASSEMBLY
This task covers:
a. Inspection
b.
Replacement
Tools:
7 / 1 6 - i n . wrench and 7/16-in. socket and handle
1 / 2 - i n . wrench
1 3 / 1 6 - i n . wrench
2 4 - m m wrench
Materials:
B r u s h , Cleaning (Appendix E, item 1)
Rag, Wiping (Appendix E, item 3)
S o l v e n t , Dry Cleaning (Appendix E, item 2)
C o m p r e s s o r Assembly
Ignition switch pushed in (Table 2-1, 8).
Equipment Condition:
B e l t guard assembly removed (para 3-11).
V - b e l t s removed (para 3-12).
a. Inspection.
Dry Cleaning Solvent
(Stoddard Solvent)
P-D-680
C o m b u s t i b l e - do not use near open flames, near welding areas, or
o n hot surfaces.
P r o l o n g e d or repeated contact of skin with liquid can cause
d e r m a t i t i s . Repeated inhalation of vapor can irritate nose and
t h r o a t and can cause dizziness.
I f any liquid contacts skin or eyes, immediately flush affected area
thoroughly with water. Remove solvent-saturated clothing. If
v a p o r s cause dizziness, go to fresh air.
W h e n handling liquid or when applying it in an air-exhausted,
partially covered tank, wear approved gloves.
W h e n handling liquid or when applying it at an unexhausted,
u n c o v e r e d tank or workbench, wear approved respirator, goggles
a n d gloves.
(1) Clean compressor as necessary to perform inspection. Use brush, cloth, and solvent
as required.
(2) Inspect compressor for excess wear or damage.
3-20
