TM 5-4310-378-14
d. R e p l a c e m e n t .
(1) Removal
( a ) S l i d e d e f e c t i v e c a r b u r e t o r (6) off mounting studs. Discard carburetor flange
g a s k e t (2), insulating plate gasket (4), and air cleaner gasket (7).
Dry Cleaning Solvent
(Stoddard Solvent)
P-D-680
C o m b u s t i b l e - do not use near open flames, near welding areas,
o r on hot surfaces.
P r o l o n g e d or repeated contact of skin with liquid can cause
d e r m a t i t i s . Repeated inhalation of vapor can irritate nose and
t h r o a t and can cause dizziness.
I f any liquid contacts skin or eyes, immediately flush affected
area thoroughly with water. Remove solvent-saturated
c l o t h i n g . If vapors cause dizziness, go to fresh air.
W h e n handling liquid or when applying it in an air-exhausted,
partially covered tank, wear approved gloves.
W h e n handling liquid or when applying it at an unexhausted,
uncovered tank or workbench, wear approved respirator,
g o g g l e s , and gloves.
C l e a n carburetor mounting boss (1) on the crankcase as necessary with brush, rag,
(b)
and solvent.
(2)
Installation
O b t a i n replacement carburetor (6) and new gaskets (2, 4, 7).
(a)
S l i d e insulating plate gasket (2), carburetor insulating plate (3), and carburetor
(b)
f l a n g e gasket (4) onto carburetor mounting studs (5).
S l i d e carburetor assembly (6) onto mounting studs (5) and slide air cleaner
(c)
g a s k e t (7) against it.
(d)
S l i d e the air cleaner body (8) onto studs, with the clip down, and secure the
c o m p l e t e installation with two nuts (9).
(e)
Adjust carburetor per subparagraph c (adjustment).
3-4
