TM
5-4310-378-14
a. I n s p e c t i o n .
C o m b u s t i b l e - do not use near open flames, near welding areas,
o r on hot surfaces.
P r o l o n g e d or repeated contact of skin with liquid can cause
d e r m a t i t i s . Repeated inhalation of vapor can irritate nose and
t h r o a t and can cause dizziness.
I f any liquid contacts skin or eyes, immediately flush affected
a r e a thoroughly with water. Remove solvent-saturated
c l o t h i n g . If vapors cause dizziness, go to fresh air.
W h e n handling liquid or when applying it in an air-exhausted,
partially covered tank, wear approved gloves.
W h e n handling liquid or when applying it at an unexhausted,
uncovered tank or workbench, wear approved respirator,
g o g g l e s , and gloves.
( 1 ) Clean carburetor as necessary
u s i n g brush, rag, and solvent.
( 2 ) Inspect carburetor for damage, and
l o o s e , or missing parts.
b. S e r v i c e .
( 1 ) Close fuel shutoff. Remove screw
(1) and washer (2) holding float
c h a m b e r (3) on carburetor (4).
D i s c a r d gasket (5).
( 2 ) Empty float chamber (3) and wipe
i t clean inside and out with a
( 3 ) Install float chamber (3) and new
g a s k e t (5). Secure with washer (2)
a n d screw (l).
c. A d j u s t m e n t . W i t h t h e e n g i n e r u n n i n g ,
r o t a t e speed control lever stop screw
(1) until the engine is idling at the most
favorable speed.
3-44