Fuel Strainer Assembly

Figure 3-25. Fuel Filter Assembly, Repair.

Figure 3-26. Fuel Strainer Assembly, Service.

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
97

TM 5-4310-379-14 3-26. Fuel Strainer Assembly This task covers: a. Service b. Replace c. Repair INITIAL SETUP: Tools Materials/Parts General Mechanic's Tool Kit (NSN 5180-00-177-7033) Fuel Strainer Assembly Torque, Wrench (NSN 5120-00-554-7292) Solvent, Dry Cleaning (Item 23, Appendix D) Rags, Wiping (Item 21, Appendix D) Teflon Tape (Item 25, Appendix D) a. Service. (figure 3-26) (1) Remove screw (1) and gasket (2), and remove shell (3) and gasket (4). (2) Pour excess fuel into suitable container. (3) Remove element (5), retainer (6), seat (7), seal (8), seat (9), and spring (10). WARNING Dry cleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and property. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. Flash point of solvent is 100-138°F (38-600C). (4) Clean all items, except seals and gasket, with dry cleaning solvent and dry thoroughly. (5) Install spring (10), seat (9), seal (8), seat (7), retainer (6), and element (5). (6) Install shell (3) and gasket (4) and secure with screw (1) and gasket (2). Tighten screw (1) just enough to prevent fuel leakage. 3-72

Privacy Statement
Press Release
Contact