Injector Control.

Figure 4-2. Fuel Manifold Connections, Replace.

Figure 4-3. Fuel Injector Control Rack, Adjust.

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
223

TM 5-4310-379-14 4-9. Injector Control. This task covers: a. Adjust b. Replace c. Repair INITIAL SETUP Tools Equipment Condition General Mechanic's Tool Kit Rocker cover removed (para. 3-39) (NSN 5180-00-177-7033) Wrench, Torque (NSN 5120-00-554-7292) ¼ in. Star 12 Point Socket (NSN 5120-00-817-1187) Materials/Parts Injector Control Solvent, Dry Cleaning (Item 23, Appendix D) Rags, Wiping (Item 21, Appendix D) a. Adjust. (figure 4-3) (1) Loosen screw (1) and disconnect throttle cable (2). (2) Loosen two adjusting screws (3) and (4) on front rack control lever (5). (3) Loosen two adjusting screws (6) and (7) on rear rack control lever (8). (4) Move speed control lever (9) to maximum speed position. (5) Move stop lever (10) to run position and hold in place. (6) Tighten adjusting screw (6) until it comes into contact with control tube (11). (7) Tighten adjusting screw (7) until it bottoms on control tube (11). (8) Fully tighten both adjusting screws (6) and (7) evenly. (9) The adjuster rack (12) should move back to its original position when properly adjusted. (10) Hold rear rack control (8) to full fuel position. (11) Tighten adjusting screw (3) until front rack control lever(5) is in full fuel position. (12) Tighten adjusting screw (4) until it bottoms lightly on control tube (11). (13) Tighten both adjusting screws (3) and (4) evenly. (14) Install throttle cable (2) and tighten screw (1). Change 1 4-10

Privacy Statement
Press Release
Contact