TM 5-4310-379-14
4-22. Power Take-off Assembly (Cont).
b.
Removal. (figure 4-27)
(1)
Mark location of collet (1) and remove three screws (2) and washers (3).
(2)
Install one screw (2) into threaded hole (4) and tighten screw (2) to press pulley (5) off collet (1) and remove
collet (1) and pulley (5).
(3)
Connect suitable lifting device to PTO (6).
(4)
Remove 12 screws (7) and lockwashers (8) and remove PTO (6) and clutch assembly (9) and three clutch discs
(10).
(5)
Using puller, remove pilot bearing (11).
(6)
Loosen two fitting nuts (12) and remove grease line (13).
(7)
Bend out lockwasher (14) and remove nut (15), lockwasher (14), and clutch assembly (9).
(8)
Loosen screw (16) and remove handle (17).
(9)
Loosen two screws (18).
(10)
Move shaft (19) either right or left and remove two keys (20), shaft (19), and yoke (21).
4-66