TM 5-4310-379-14
5-12. Governor Assembly.
This task covers:
Repair
INITIAL SETUP:
Tools
Materials/Parts (Cont)
General Mechanic's Tool Kit
(NSN 5180-00-177-7033)
Rags, Wiping (Item 20, Appendix D)
Bearing Remover (PN J 21967-1)
Grease, Automotive and Artillery (Item 15,
Governor Cover and Bearing Installer (PN J 21068)
Appendix D)
Governor Housing Bearing Installer (PN J 9196)
Micrometer (NSN 5210-00-554-7134)
Wrench, Torque (NSN 5120-00-554-7292)
Equipment Condition
Materials/Parts
Governor assembly removed (para. 4-11).
Housing Gasket
Solvent, Dry Cleaning (Item 23, Appendix D)
(1)
Disassemble. (figure 5-8)
(a)
Remove four screws (1), three lockwashers (2), spacer (3) and remove bracket (4), cover (5), and
gasket (6).
(b)
Remove clip (7) and remove rod (8).
(c)
Loosen screw (9) and remove lever (10) and spring (11).
(d)
Remove retainer (12) and remove washers (13), o-ring (14), and shaft (15).
(e)
Remove two screws (16) and washers (17) and remove housing (18), gasket (19), plunger (20),
spring (21), shims (22) and spring retainer (23).
(f)
Remove screw (24) and lockwashers (25) and remove cover (26) and gasket (27).
(g)
Loosen screw (28) and remove lever (29).
(h)
Loosen set screw (30) and remove shaft (31), washer (32), o-ring (33), and spring lever (34).
(i)
Remove clip (35) and washer (36) and remove arm (37).
(j)
Remove plunger guide (38).
(k)
Remove flyweight carrier assembly (39).
(I)
Bend out tab on lockwasher (40) and remove screw (41) and lockwasher (40).
Change 1 5-28
