TM 5-4310-379-14
5-12. Governor Assembly (Cont).
(m)
Support inner race of bearing (42) and press weight shaft (43) from bearing (42).
(n)
Remove thrust key retainer (44) and two thrust keys (45).
(o)
Remove riser (46) and thrust bearing (47).
(p)
Remove screw (48), washer (49), lockwasher (50) and flat washer (51).
(q)
Remove expansion plug (52) from governor housing (53).
(r)
Press shaft (54) out of fork (55) and remove fork (55) from governor housing (53).
(s)
Remove shaft (54) with bearing (56), washer (57) and lever (58) installed.
(t) Press shaft (54) out of lever (58) and bearing (56) and remove washer (57).
(u)
Remove plug (59).
(v)
Remove plug (60).
(w)
Using bearing remover, remove bearing (61) from housing (18).
(x)
Using bearing remover, remove bearing (62) from housing (18).
(y)
Press bushing (63) out of housing (53).
(z)
Press bearing (64) and bearing (65) out of cover (5).
WARNING
Dry cleaning solvent PD-680 used to clean parts is potentially dangerous to personnel and
property. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive
heat. Flash point of solvent is 100-138°F (38-60°C).
(aa)
Clean all parts with dry cleaning solvent and dry thoroughly.
(ab)
Inspect governor housing (53) if cracked or otherwise damaged, replace governor housing (53).
(ac)
Inspect cover (5) and replace if cracked, bend, or otherwise damaged.
(ad)
Inspect rod (8) and replace if bent or otherwise damaged.
(ae)
Inspect levers (10), (29), and (34) and replace all items that are cracked, bent, or otherwise
damaged.
(af)
Inspect shaft (15) and replace if worn, bent, or otherwise damaged.
(ag)
Inspect housing (18) and cover (26) and replace items that are cracked or otherwise damaged.
5-30
