TM 5-4310-379-14
(ah)
Inspect plunger (20), spring (21), shims (22) and retainer (23) and replace items that are cracked,
worn, scored, or otherwise damaged.
(ai)
Inspect shaft (31) and replace if worn, scored, or otherwise damaged.
(aj)
Inspect arm (37) and replace if bent, cracked, or otherwise damaged.
(ak)
Inspect flyweight carrier assembly (39) and replace if any item in the assembly is cracked, worn,
bent, or otherwise damaged.
(al)
Inspect fork (55) and replace if cracked, bent, or otherwise damaged.
(am)
Inspect bearing (42). Hold inner race of bearing (42) and rotate outer race. Replace bearing if rough
spots are felt or signs of wear are present.
(an)
Inspect shaft (43) and replace if bent, scored, or otherwise damaged.
(ao)
Inspect riser (46) and thrust bearing (47) and replace if riser (46) is bent, dented, cracked, or thrust
bearing (47) has rough spots or other signs of damage or either part is otherwise damaged.
(ap)
Inspect thrust key retainer (44) and two thrust keys (45) and replace items that are worn, bent,
cracked or otherwise damaged.
(aq)
Inspect bearing (56). Hold inner race of bearing (56) and turn outer race. Replace bearing (56) if
rough spots are felt or other signs of wear are present.
(ar)
Inspect bearings (61), (62), (64), and (65). Inspect needle bearings in bearings. If needles are not
free in bearings, replace bearing.
(as)
Inspect plunger guide (38) and replace if cracked, worn, or otherwise damaged.
(at)
Inspect bushing (63) and replace if scored, cracked, worn, or otherwise damaged.
5-31
