TM 5-4310-379-14
5-15. Battery Charging Alternator.
This task covers:
Repair
INITIAL SETUP:
Tools
Equipment Condition
General Mechanic's Tool Kit (NSN 5180-00-177-7033)
Alternator removed (para. 3-33).
Puller Kit Mechanical (NSN 5120-00-033-5606)
Repair.
(1)
Disassemble. (figure 5-15).
(a)
Hold pulley (1) and remote nut (2) and washer (3).
(b)
Using puller, remove pulley (1).
(c)
Remove fan (4) and outside collar (5).
(d)
Remove four screws (6) and remove front housing (7).
(e)
Tag and disconnect stator assembly leads and remove stator assembly (8).
(f)
Remove rotor assembly (9).
(g)
Remove screw (10) and tag and remove capacitor lead (11).
(h)
Remove screw (12) and remove capacitor (13).
(i)
Remove three nuts (14) and remove diode set (15).
(j)
Remove two screws (16) and remove rectifier bridge (17).
(k)
Remove two screws (18) and tag and disconnect lead (19).
(I)
Remove screw (20) and remove brush and holder (21).
(m)
Remove two screws (22) and remove regulator (23) and lead (19).
(n)
Remove nut (24), washer (25), insulator (26), spacer (27), spacer (28), and stud (29) from housing (30).
(o)
Press bearing (31) out of housing (30).
(p)
Remove three screws (32) and remove bearing retainer (33).
5-50
