TM 5-4310-379-14
5-14.
Starter (Cont).
(2)
Assemble. (figure 5-14)
(a)
Install field coil (1) and insulating pad (2) and secure with four pole shoes (3) and
eight screws (4).
(b)
Install insulator (5) and bushing (6) and insert stud (7) through body (8) and secure with insulator (9),
washer (10), and nut (11).
(c)
Install bushing (12) in cover (13).
(d)
Install bushing (14) in lever housing (15).
(e)
Install bushing (16) in housing drive (17).
(f)
Install drive assembly (18) and lever (19) in housing drive (17), and secure with two O-rings (20), pin (21),
and snap ring (22).
(g)
Install washer (23), boot (24), retainer (25), spring (26), and retainer (27) on plunger (28) and secure with
snap ring (29).
(h)
Install plunger (28) in lever (19) and secure with nut (30).
(i)
Install gasket (31) and plug (32).
(j)
Install armature (33).
(k)
Install seal (34) and washer (35).
(I)
Install housing (15) as marked and O-ring (36) and secure with five screws (37) and lockwashers (38).
(m)
Install brake washer (39), gasket (40), and housing drive (17) as marked, and secure with five long screws
(41) and one short screw (42).
(n)
Install solenoid (43) and bracket (44), and secure with four screws (45).
(o)
Install lead (46) and tighten nut (47).
(p)
Install spacer (48), lead (49), washer (50), lockwasher (51), and nut (52). Install lockwasher (53) and lead
(46) and secure with nut (54).
(q)
Install brush spring (55) and brushes (56) and secure with pin (57).
(r)
Install brush spring (58) and brushes (59) and secure with pin (60).
(s)
Install cover (13) and O-ring (61) and secure with four screws (62) and lockwasher (63).
5-46