Power Take-Off Assembly. - TM-5-4310-379-14

The oil seal spacer used with older oil seals should be removed from the cover.

Figure 5-32. Power Take-Off Assembly, Repair.

TM-5-4310-379-14 Compressor Air Reciprocating Electric Motor Driven Reciprocating Electric Motor Driven 15 CFM at 175 PSI Manual
Page Navigation
471

TM 5-4310-379-14 5-25. Power Take-Off Assembly. This task covers: Repair INITIAL SETUP: Tools Equipment Condition General Mechanic's Tool Kit (NSN 5180-00-177-7033) Power take-off removed (para. 4-22). Puller Kit, Mechanical (NSN 5120-00-033-5606) Materials/Parts Solvent, dry cleaning (Item 23, Appendix D) Rags, Wiping (Item 21, Appendix D) Repair. (figure 5-32) (1) Remove pilot bearing (1). (2) Loosen fitting nut (2) and remove grease line (3) from clutch assembly (4). (3) Bend lockwasher (5) away from nut (6) and remove nut (6), lockwasher (5), clutch assembly (4) and drive key (7). (4) Loosen bolt (8) and remove handle (9). (5) Loosen two bolts (10) and slide yoke (11) to left or right and remove two keys (12) and (13) and remove shaft (14) and yoke (11). (6) Remove screw (15) and lockwasher (16) and remove lock (17). (7) Remove bearing retainer (18) and bearing cup (19). (8) Remove output shaft (20) with bearings (21) and (22) installed. NOTE There are 3 holes at rear of housing for removal of inner bearing cup. Insert a punch in houses and tap alternately at three points to remove inner bearing cup. (9) Remove inner bearing cup (23). 5-106

Privacy Statement
Press Release
Contact