TM 5-4310-386-14
6-16. Alternator.
This task covers:
Repair
INITIAL SETUP
Tools
Equipment Condition
General Mechanic's Tool Kit
Compressor unit shut down (para. 2-13).
(NSN 5180-00-177-7033)
Alternator removed (para 4-44).
Materials/Parts
Alternator
Repair.
(1)
Disassemble. (figure 6-18)
(a)
Remove nut (1) and lockwasher (2).
(b)
Remove pulley (3), fan (4), and spacer (5).
(c)
Remove four nuts (6) and bolts (7).
(d)
Remove front housing (8) from rear housing (9).
(e)
Remove front bearing (10) and front bearing retainer (11).
(f)
Remove woodruff key (12), rotor assembly (13), rear bearing (14), and stator assembly (15).
(g)
Remove bolt (16), insulator sleeve (17), diode (18), and diode (19).
(h)
Remove rear bearing (20), insulator washer (21), and insulator sleeve (22).
(i)
Remove two screws (23), terminal ground (24), capacitor output (25), and bush assemble (26).
(j)
Remove nut (27) and washer (28).
(k)
Remove nut (29), washer (30), and insulator washer (31).
(l)
Remove three nuts (32), washer (33), insulator washer (34), and insulator sleeve (35).
(m)
Inspect front housing (8) and rear housing (9) and replace entire alternator if either housing is
cracked or otherwise damaged.
(n)
Inspect stator assembly (15) and replace if wiring is burnt or stator assembly (15) is otherwise
damaged.
6-44