TM 5-4310-386-14
6-17. Starter.
This task covers:
Repair
INITIAL SETUP
Tools
Equipment Condition
General Mechanic's Tool Kit
Compressor unit shut down (para. 2-13).
(NSN 5180-00-177-7033)
Starter removed (para. 4-47).
Repair.
(1)
Disassemble. (figure 6-20)
(a)
Remove nut (1), lockwasher (2), and screw (3).
(b)
Remove three screws (4) and remove relay (5).
(c)
Remove two nuts (6) and washers (7).
(d)
Remove two screws (8) and cap (9).
(e)
Remove seal (10), half-moon ring (11), and two washers (12).
(f)
Remove four screws (13).
(g)
Remove commutator bearing (14), bearing bushing (15), four brushes (16), compression springs
(17), and brush holders (18).
(h)
Remove two threaded pins (19), armature (20), and winding (21).
(i)
Remove bearing bushing support (22), pinion (23), bearing bushing (24), seal (25), washer (26), shaft
lever (27), drive bearing (28), and bearing bushing (29).
(j)
Inspect brushes (16) and replace if worn, cracked, or otherwise damaged.
(k)
Inspect drive bearing (28), winding (21), and commutator bearing (14), and replace all items that are
cracked or otherwise damaged.
(l)
Inspect armature (20) and replace if wires are burnt or armature (20) is otherwise damaged.
(m)
Inspect pinion (23) and replace if teeth are worn, chipped, missing or pinion (23) is otherwise
damaged.
(n)
Inspect bushings (15), (24), and (29) and replace if cracked, worn, or otherwise damaged.
(o)
Inspect shaft lever (27) and replace if cracked, bent, or otherwise damaged.
(p)
Inspect ignition switch (5) and replace if damaged.
6-48
