TM 5-4310-386-14
6-16. Alternator (Cont).
(o)
Inspect rotor assembly (13) and replace if wiring is burnt or rotor assembly is otherwise damaged.
(p)
Inspect diodes (18) and (19), bush (26) and replace any item that has signs of burnt wire, body is
cracked, or item is otherwise damaged.
(q)
Inspect front bearings (10) and (14) and replace if worn or otherwise damaged.
(r)
Inspect fan (4), pulley (3), and replace any item that is bent, cracked, or otherwise damaged.
(s)
Inspect bolt (7), spacer (5), insulator washers (21), (31), and (34), insulator sleeves (17), (22), and
(35), terminal ground (24), and washers (28), (30), and (33), and nut (29) and (32) ,and replace all
items if any one is cracked, worn, stripped, or otherwise damaged.
(2)
Assemble. (figure 6-19)
(a)
Install insulator sleeve (1), insulator washer (2), washer (3), and three nuts (4).
(b)
Install insulator washer (5), washer (6), and nut (7).
(c)
Install bush assembly (8), capacitor output (9), terminal ground (10), and secure with two screws
(11).
(d)
Install washer (12) and nut (13).
(e)
Install insulator sleeve (14), insulator washer (15), and rear bearing (16).
(f)
Install diode (17) and (18) into rear housing (19) and secure with insulator sleeve (20) and bolt (21).
(g)
Install stator assembly (22), rear bearing (23), rotor assembly (24), and woodruff key (25).
(h)
Install front bearing retainer (26), front bearing (27), and front housing (28), and secure with four
bolts (29) and nuts (30).
(i)
Install spacer (31), fan (32), pulley (33), and secure with lockwasher (34) and nut (35).
FOLLOW-ON MAINTENANCE
Install alternator (para. 4-44).
6-46
