TM 5-4310-386-14
6-17. Starter (Cont).
(2)
Assemble. (figure 6-21)
(a)
Install bearing bushing (1), shaft lever (2), washer (3), seal (4), bearing bushing (5), pinion (6),
bearing bushing support (7) into drive bearing (8).
(b)
Install winding (9), armature (10), and two threaded pins (11).
(c)
Install brush holders (12), four compression spring (13), brushes (14), bearing bushing (15), and
commutator bearing (16).
(d)
Install two washers (17), half-moon ring (18), and seal (19).
(e)
Install cap (20) and secure with two screws (21).
(f)
Install two washers (22) and nuts (23).
(g)
Install four screws (24).
(h)
Install ignition switch (25) and secure with three screws (26).
(i)
Install screw (27), washer (28), and nut (29).
6-50
