TM 5-4310-387-14
4-32. Cold Start Assembly.
This task covers:
a.
Replace
INITIAL SETUP
Tools
Materials/Parts
General Mechanic's Tool Kit (NSN 5180-00-177-7033)
Cold Start Assembly
Replace. (figure 4-33)
(1)
Remove two wing nuts (1) and bracket (2).
(2)
Unscrew tank (3) from base (4).
(3)
Remove gasket (5).
(4)
Loosen two connector nuts (6) and remove line (7).
(5)
Remove two nuts (8), bolts (9), lockwashers (10), cap and chain (11), bracket (12), and base (4).
(6)
Remove atomizer (13) from air cleaner (14).
(7)
Remove two screws (15), washers (16), and bracket (17).
(8)
Install bracket (17) and secure with two screws (15) and washers (16).
(9)
Note position of orifice in atomizer (13).
(10)
Install atomizer (13) in air cleaner (14). Ensure orifice points at cylinder head (18).
(11)
Install base (4), bracket (12), cap and chain (11), two lockwashers (10), bolts (9), and nuts (8).
(12)
Install line (7) and tighten two connector nuts (6).
(13)
Install gasket (5) and tank (3).
(14)
Install bracket (2) and secure with two wing nuts (1).
4-70
