TM 5-4310-387-14
5-30. Speed Control Assembly .
This task covers:
Replace
INITIAL SETUP
Tools
Equipment Condition
General Mechanic's Tools Kit (NSN 5180-00-177-7033)
Cylinder head removed (para. 5-29).
Wrench, Torque (NSN 5120-00-554-7292)
Fuel lines removed (para. 4-24).
Engine crankcase oil screen removed (para. 4-31).
Materials/Parts
Engine removed (para. 4-23).
Crank handle guide removed (para. 4-30).
Gasket
Locking Tab
Reference
Speed Control Assembly
Appendix F Torque Values
Replace. (figure 5-44)
(1)
Remove six bolts (1) and remove cover (2) and gasket (3).
(2)
Remove nut (4), washer (5), lever (6), plate (7), pin (8), and spring (9).
(3)
Remove two screws (10), plate (11), and gasket (12).
(4)
Remove nut (13), locking tab (14), and screw (15).
(5)
Remove spring retainer (16), shaft (17), washer (18), and spring (19).
(6)
Remove governor arm (20) and spring (21).
(7)
Install spring (21) in governor arm (20).
(8)
Position governor arm (20) in cover (2). Ensure rack pin (22) engages slot in governor arm (20).
(9)
Install spring (19), washer (18), shaft (17), and secure with retainer (16).
(10)
Install screw (15), new locking tab (14), and nut (13).
(11)
Install new gasket (12), plate (11), and two screws (10).
(12)
Install spring (9), pin (8), plate (7), lever (6), washer (5), and nut (4).
(13)
Remove two screws (22), compression release mechanism (23) and gasket (24).
(14)
Turn gear (25) and aline timing mark on gear (25) with mark on cover (2).
5-96
