TM 5-4310-387-14
Key
Control or Indicator
Function or Use
1
Speed Control Lever
Used to start and stop the engine and to regulate engine
speed.
2
Cold Start Primer
Used when starting a cold engine. It supplies extra fuel
for the start up cycle.
3
Automatic Compression Release
Used when starting the diesel engine. When set to
"START" position it releases the compression in the
cylinder and makes cranking the engine easier.
4
Crank Handle
Used to crank start the engine, and to set the automatic
compression release.
5
Cold Start System (Optional)
Used when starting the engine in an extreme cold
weather area. Provides a fast burning gas to the cylinder
to aid in combustion
Section II. OPERATOR PREVENTIVE MAINTENANCE
CHECKS AND SERVICES (PMCS)
Paragraph
Page
2-4
General ...........................................................................................................................
2-5
2-5
Purpose of PMCS Table...................................................................................................
2-6
2-6
Explanation of Columns ..................................................................................................
2-6
2-7
Reporting Deficiencies ....................................................................................................
2-6
2-8
Equipment is Not Ready/Available if Column ..................................................................
2-6
2-9
Special Instructions .........................................................................................................
2-6
2-4.
General. Operator PMCS are performed to ensure that the 5.1 CFM air compressor is ready for operation at all
times. Perform the checks and services at the specified intervals.
a.
Before you Operate. Always keep in mind the CAUTIONS and WARNINGS. Perform your before (B) PMCS prior
to the equipment leaving its containment area or performing its intended mission.
b.
While you Operate. Always keep in mind the CAUTIONS and WARNINGS. Perform your during (D) PMCS when
the equipment is being used in its intended mission.
c.
After you Operate. Perform your after (A) PMCS after the equipment has been taken out of its mission mode or
returned to its containment area.
d.
If Equipment Fails to Operate. Perform proper troubleshooting procedures. Report deficiencies on the proper
forms as described in DA PAM 738-750, The Army Maintenance Management System.
2-5
