TM-5-4310-389-14
10.
Remove the safety valve (30) from the first condensate block. Remove the four bolts that secure the first
separator block to the base plate. Remove the 0-ring and the vortex element from the separator block.
11.
Remove heater element (17) from base plate.
c.
Inspect and clean separator assembly.
CAUTION
All breathing air compressor parts will be cleaned in accordance with the prescribed procedures
outlined in NEDU 7121. Refer to Appendix A. Caution must be taken when cleaning parts to ensure
that parts are not contaminated. THIS IS YOUR BREATHING AIR.
1.
Inspect all 0-rings, pistons, and seats for damage, nicks, or cuts. Replace, if necessary.
2.
Inspect the solenoid piston seats (there is a seat on both ends) for unusual wear or damage. Replace, if
necessary.
3.
Clean out condensation blocks and condensate valves. Inspect for signs of wear or damage.
4.
Clean the base and condensate galleys (heater element must be removed). Check for signs of corrosion
and damage.
d.
Reassembly.
1.
Reassemble condensate blocks and install blocks on the condensate base plate.
2.
Reassemble the condensate valves ensuring proper assembly for each block.
3.
Assemble condensate valves to the condensate block.
4.
Assemble the drain solenoid and reinstall on the first condensate drain valve assembly.
5.
Reinstall heater assembly.
6.
Install the three tubing assemblies on the condensate drain valves.
7.
Reinstall condensate block assembly to the compressor and reinstall wires for the heating element. Install
solenoid windings over the solenoid posts and secure.
4-119
