TM-5-4310-389-14
13.
The end clearance must be within the limits given in the specifications. If it is on the low side, correct by
driving the gear wheel slightly in the direction of the front cover of the camshaft. If the end clearance is on the high
side, dismantle the camshaft gear wheel and drive the check pin outwards by a corresponding amount.
14.
Install the push rods.
15.
Mount the rocker arm shaft support.
16.
Adjust the valve clearance (paragraph 3-23).
17.
Check the gaskets on the cylinder head covers and renew, if necessary. Apply jointing compound when
assembling the gaskets.
18.
Align and secure in position the cylinder head covers.
19.
Reinstall fuel injection pump (paragraph 5-12).
5-51
