TM-5-4310-389-14
CAUTION
Camshafts are designed for duties up to 2,300 rpm. Do not install one type in place of another.
3.
Assemble the thrust washer on the camshaft
4.
Drive the check pin of the camshaft gear wheel about 0.080 inch (2 mm) in the direction of the marked side.
NOTE
Timing marks may vary from engine to engine.
5.
Install the camshaft gear wheel so that the tooth marked 1 engages in the gap between teeth marked 15 and
16 of the crankshaft gear wheel.
OR
5.
Install the camshaft gear wheel so that the tooth marked engages the crankshaft in a straight line.
6.
Rotate the camshaft so that the holes there register with the holes in the camshaft gear wheel.
7.
Secure the camshaft gear wheel on the camshaft.
8.
Mount the eccentric sheet metal ring on the camshaft gear wheel.
9.
Measure the distance from the front face of the front camshaft cover to the joint surface.
10.
Drive the check pin in the camshaft gear wheel so that it clears the joint surface by the distance from the
front face of the cover plus 0.40 to 0.80 inch (1 to 2 mm).
11.
Coat a new gasket with grease and stick it in position on the front of the crankshaft cover. Mount the crank
handle bearing cover.
12.
Check the end clearance of the camshaft.
5-50
