TM-5-4310-389-14
CAUTION
A maximum mixture of regular-grade gasoline is 30 percent; when
mixing more than 30 percent, use kerosene only. Never use premium
fuel.
CAUTION
Check hoses and ducts for cracks or other cold weather damage prior to
starting compressor. Keep fuel tank full to minimize moisture
condensation.
a.
Locate ignition switch.
b.
Pull the engine throttle OUT 1/4 to 1/2 (press button on top of throttle control to release from position).
c.
Disengage clutch.
d.
Turn safety bypass switch to ON.
e.
Press and hold set-up button on engine oil pressure gauge.
f.
Press and hold relay latch button in.
g.
While engine is cranking, press ether injection knob (figure 2-17) for two seconds. (The flow will start when the
knob is released.)
CAUTION
Do not actuate starter for more than 20 seconds at a time. Wait one
minute between each starting attempt.
h.
Let the engine run about five minutes before engaging the clutch.
NOTE
Engage clutch before turning safety bypass switch to OFF.
2-20
