TM 5-4310-393-14
b.
Remove Oil Seal (5).
WARNING
DEATH OR SERIOUS INJURY COULD
OCCUR IF FUEL IS NOT HANDLED
CAREFULLY. USE IN A WELL
VENTILATED AREA AWAY FROM
OPEN FLAME, ARCING EQUIPMENT,
IGNITION SOURCES, HEATERS, OR
EXCESSIVE HEAT. ENGINE MUST
BE SHUT DOWN AND COOL BEFORE
REFUELING. ALWAYS STORE FUEL
IN PROPER, MARKED CONTAINERS.
DO NOT SMOKE.
FIGURE 5-50. OIL SEAL
WARNING
DEATH OR SERIOUS INJURY COULD OCCUR IF COMPRESSED AIR IS DIRECTED
AGAINST THE SKIN. DO NOT USE COMPRESSED AIR FOR CLEANING OR
DRYING UNLESS THE PRESSURE HAS BEEN REDUCED TO 30 PSI (2.06 BAR) OR
LESS. WHEN WORKING WITH COMPRESSED AIR ALWAYS USE CHIP GUARDS,
EYE PROTECTION, AND OTHER PERSONAL EQUIPMENT.
c.
Clean oil seal components with diesel fuel and dry with low pressure compressed air.
d.
Inspect all components for damage or excessive wear. Replace any component that is severely damaged
or worn.
B.
Replace.
1.
Replacing the Oil Seal.
a.
oil seal in support (Figure 5-50, Item 1).
b.
Fill groove of oil seal with grease.
c.
Lubricate new preformed packing (4) with grease and install it in preformed packing groove In support.
d.
Install support (1) onto crankshaft with two security plates (2) and four hex screws (3).
5-46
