TM 5-4310-451-14
5-41. ROCKER ARM MAINTENANCE (Con’t).
d. ASSEMBLY
1.
Install two bushings (12) in clevis yoke (14).
2.
Install clevis yoke (14) on rocker arm (2) with pin (13).
3.
Install bushing (11) in rocker arm (2).
4.
Ream bushing (11) to 0.875 in. (22.225 mm).
e. INSTALLATION
1.
Thread three rocker arms (2) on pushrods (9) until end of pushrods are above inside of clevis yoke (14).
2.
Coat shaft (7) with lubricating oil and slide through three rocker arms (2).
NOTE
Ensure that finished faces of brackets are next to rocker arms.
3.
Install two brackets (8) on cylinder head (4) with two screws (3).
4.
Position three rocker arms (2) down on valve bridge (15).
5.
Hold each pushrod (9) while tightening locknut (10).
TA705027
5-148
