TM 5-4310-451-14
5-58. FUEL INJECTOR TESTING.
This Task Covers:
a. Fuel Injector Test Kit Setup
b. Testing
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Fuel injector removed (see paragraph 5-57).
• Injector test oil (Item 24, Appendix E)
Tools/Test Equipment:
• Tie-down straps (Item 39, Appendix E)
• Injector test kit, J23O010A
General Safety Instructions:
• Rack tester kit, J22396
• DO NOT perform this procedure near fire, flames, or
• Spray tip gage, J9462-02
sparks.
·
• When testing or adjusting fuel injectors, DO NOT
place hands or arms in front of injector spray tip.
a. FUEL INJECTOR TEST KIT SETUP
WARNING
No open flame, welding, grinding, smoking, or use of heat producing devices,
permitted nearby when using fuel. Fuel burns easily and fumes are explosive.
Keep battery disconnected. DO NOT breathe fuel fumes. They are toxic and can
cause serious medical problems. Failure to observe these precautions may cause
serious Injury or death to personnel.
1.
Loosen setscrew (3).
2. Install pump lever (2) on test kit (1) and tighten setscrew (3).
TA705056
5-184
