TM 5-4310-451-14
Section II. SERVICE UPON RECEIPT
Paragraph
Page
Number
Paragraph Title
Number
4-4
General .......................................................................................................
4-2
4-5
Inspection Instructions ................................................................................
4-2
4-6
Prepare for Use ..........................................................................................
4-2
4-7
Servicing Instructions ..................................................................................
4-2
4-4.
GENERAL.
When a new, used, or reconditioned air compressor unit is first received, determine whether it has been properly
prepared for service and is in condition to perform its mission. Follow inspection instructions in paragraph 4-5 and
servicing instructions in paragraph 4-7.
4-5.
INSPECTION INSTRUCTIONS.
a.
Refer to DD Form 1397 for procedures on unpacking air compressor unit.
b.
Remove all straps, plywood, tape, seals, and wrappings.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective goggles and
gloves, and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO
NOT breathe vapors. DO NOT use near open flame or excessive heat. The solvent’s flash point is
100°F-138°F (38°C-59°C). If you become dizzy while using cleaning solvent, immediately get fresh
air and medical help. If solvent contacts eyes, immediately wash your eyes and get medical aid.
c.
Remove rust preventive compound from coated exterior parts of the air compressor unit using dry
cleaning solvent (Item 38, Appendix E) and rags (Item 35, Appendix E).
d.
Inspect air compressor unit for damage incurred during shipment. Check also to see if the equipment has
been modified.
e.
Check equipment against packing list to ensure that shipment is complete. Report any discrepancies in
accordance with instructions in DA Pam 738-750.
4-6.
PREPARE FOR USE.
DA Form 2258, attached to the air compressor unit, contains the checklist of items that must be accomplished
before use. All items on DA Form 2258 must be properly completed before the air compressor unit can be safely
operated.
4-7.
SERVICING INSTRUCTIONS.
a.
Perform all Operator/Crew and Unit PMCS. Schedule the next PMCS on DD Form 314.
b.
Lubricate all lubrication points as described in Lubrication Instructions (see Chapter 3, Section I)
regardless of interval.
c.
Report any problems on DA Form 2404.
4-2
