TM 5-4310-452-14
4-29. ENGINE STOP CABLE REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Engine oft.
•·One lockwasher
• Left door assembly open,
Tools/Test Equipment:
• General mechanic's tool kit
a.
REMOVAL
1.
Loosen capscrew (2) and setscrew (5).
2.
Remove engine stop cable (1) from clamp (3), cable bracket (7), and pin (4) on stop lever (6).
3.
Remove nut (10) and lockwasher (9) from engine stop cable (1). Discard lockwasher.
4.
Remove engine stop cable (1) through control panel (8).
b.
INSTALLATION
1.
Install engine stop cable (1) through control panel (8).
2.
Install and tighten nut (10) and new lockwasher (9) on engine stop cable (1).
3.
Install end of engine stop cable (1) in clamp (3) and pin (4).
4.
Tighten capscrew (2) on clamp (3). Pull slack out of engine stop cable (1) and tighten setscrew (5) on pin (4).
5. Check operation of engine stop cable (1) before starting engine.
FOLLOW-ON TASKS:
•·Close left door assembly.
4-54
