TM 5-4310-452-14
Section VII. EXHAUST SYSTEM MAINTENANCE
Paragraph
Page
Number
Title
Number
4-30
Protective Cap Assembly Replacement .............................................................................. 4-55
4-31
Muffler and Pipe Replacement ........................................................................................... 4-56
4-30. PROTECTIVE CAP ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Engine off and cold.
• Four self-locking bolts
•·Right door assembly open.
• Four self-locking nuts
Tools/Test Equipment:
• General mechanic's tool kit
Personnel Required: Two
a.
REMOVAL
1.
Remove 4 self-locking bolts (1) and nuts (5) from
cap assembly (2). Discard self-locking bolts and
nuts.
2. Remove cap assembly (2) and exhaust boot (3) from
compressor unit roof assembly (4).
b. INSTALLATION
NOTE
Install cap assembly with hinge on front
side of trailer.
1. Install exhaust boot (3) and cap assembly (2) on
compressor unit roof assembly (4).
2. Line up holes in exhaust boot (3) and cap assembly
(2). Install 4 new self-locking bolts (1) and nuts (5)
in cap assembly.
FOLLOW-ON TASKS:
• Close right door assembly.
4-55
