TM 5-4310-452-14
4-39. STARTER MOTOR REPLACEMENT (Con't).
b. INSTALLATION
NOTE
If solenoid was removed, perform step 1. If not, go to step 2.
1.
Position solenoid (5) in place on starter (1). Install 3 screws (4) in solenoid (5) and starter (1).
2.
Position starter (1) in opening of flywheel housing and install 3 new lockwashers (2) and bolts (3).
3.
Install ground strap (16), new lockwasher (15), and nut (14) on solenoid terminal (1 7).
4.
Install capscrew (11), clamp (12), and electrical lead (13) on solenoid (5).
5.
Install electrical lead (7), battery cable (8), new lockwasher (9), and nut (10) on solenoid terminal (6).
FOLLOW-ON TASKS:
• Connect battery cables (see paragraph 4-57).
• Close right door assembly.
• Start engine and check starter operation (see paragraph 2-1 2).
4-81
