TM 5-4310-452-14
4-42. BELT BREAK SWITCH REPLACEMENT.
This Task Covers:
a. Inspection
c. Installation
b. Removal
Initial Setup:
Equipment Conditions:
Tools/Test Equipment:
• Engine off.
• General mechanic's tool kit
• Battery cables disconnected (see paragraph
• Multimeter
4-57).
• Left and right door assemblies open.
a.
INSPECTION
1.
Remove 2 wire leads (4) from belt break switch (3).
2. Using multimeter, test continuity and function of belt
break switch (3).
b. REMOVAL
1. Remove nut (1) and belt break switch (3) from
retainer (2).
NOTE
If retainer is damaged or must be
removed for access, perform step 2.
2. Remove bolt (5), nut (6), and retainer (2) from
engine.
c. INSTALLATION
NOTE
If retainer was removed, perform step 1. If not, go to step 2.
1.
Position retainer (2) in place on engine and install nut (6) and bolt (5).
2.
Position belt break switch (3) through hole in retainer (2). Install nut (1) on belt break switch.
3.
Install 2 wire leads (4) on belt break switch (3).
FOLLOW-ON TASKS:
• Connect battery cables (see paragraph 4-57).
• Close left and right door assemblies.
TA505472
4-85
