TM 5-4310-452-14
Section VI. FRAME AND TOWING ASSEMBLY MAINTENANCE
5-24. FRAME ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
• Tool boxes removed (see paragraph 4-79).
• Twenty-four lockwashers
• Hose reel support bracket removed (see para-
graph 4-103).
Tools/Test Equipment :
• Engine removed (see paragraph 5-5).
• General mechanic's tool kit
• Rear end panel assembly removed (see para-
graph 5-29).
• Air compressor housing removed (see para-
graph 5-32).
a.
REMOVAL
1.
Remove 4 screws (14), lockwashers (16), nuts (17), and loop clamps (15) from rear frame section (13). Discard
lockwashers.
2.
Remove 10 capscrews (1), bevel washers (10), lockwashers (11), nuts (12), 2 flatwashers (2), and rear frame section
(13) from frame (6). Discard lockwashers.
3.
Remove 10 capscrews (3), bevel washers (7), lockwashers (8), nuts (9), 2 flatwashers (4), and front frame section (5)
from frame (6). Discard lockwashers.
b.
INSTALLATION
1.
Position front frame section (5) in place on frame (6) and install 10 capscrews (3), bevel washers (7), new
lockwashers (8), 2 flatwashers (4), and nuts (9).
2.
Position rear frame section (13) in place on frame (6) and install 10 capscrews (1), bevel washers (10), new
lockwashers (11), 2 flatwashers (2), and nuts (12).
3.
Position electrical wiring harnesses and 4 loop clamps (15) in place on rear frame section (13), and install 4 screws
(14), new lockwashers (16), and nuts (17).
5-54
