TM 5-4310-452-14
5-29. REAR END PANEL ASSEMBLY REPLACEMENT.
This Task Covers:
a. Removal
b. Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
Engine off.
Two lockwashers
Engine starting aid removed (see paragraph
Seventeen rivets
4-28).
Control panel removed (see paragraph 4-49).
Tools/Test Equipment:
Indicator panel removed (see paragraph 4-55).
General mechanic's tool kit
Air discharge hose assembly removed (see
Electric, drill
paragraph 4-99).
Twist drill bit, 3/16 in.
Control panel light removed (see paragraph 4-49).
Left and right door assemblies closed.
Personnel Required: Two
Elbow and adapter from service air manifold
removed (see paragraph 4-100).
Battery cables disconnected (see paragraph
4-57).
a.
REMOVAL
1.
Remove 21 screws (1) from rear end panel assembly (2). Remove rear end panel assembly from trailer.
NOTE
If rear end panel assembly is damaged and must be replaced, perform step 2. If not, go to step 8.
2.
Remove 2 screws (11), lockwashers (13), nuts (14), and magnetic catch (12) from rear end panel assembly (2).
Discard lockwashers.
3.
Using drill and twist drill bit, remove 3 rivets (10) from control panel hinge (8) and rear end panel assembly (2).
Discard rivets.
4.
Remove control panel cover (9) and hinge (8).
5.
Using drill and twist drill bit, remove 14 rivets (7) and 3 plates (4, 5, and 6) from rear end panel assembly (2).
Discard rivets.
6.
Inspect fiberglass panel (3) and replace if necessary (see paragraph 5-33).
b.
INSTALLATION
NOTE
If rear end panel assembly is new, begin with step 1. If not, go to step 4.
1.
Position plates (4, 5, and 6) in place on rear end panel assembly (2) and install 14 new rivets (7).
2.
Position control panel cover (9)'and hinge (8) in place and install 3 new rivets (10).
5-68