Fitting
1 Lower drawer
Swivel
2 Flexible extension adapter (2)
Engine start rope
3 Flexible extension adapter (2)
4 Extension adapter
Straight Swivel
Hose coupling
5 Easy out tool
Pipe plug (2)
6 Coupler (2)
Hydraulic fitting
(6)
7 Easy out tool
8 Hose coupling (2)
Hydraulic fitting
(6)
9 Coupler (2)
Hydraulic fitting
(6)
10 Button head fitting (6)
Hydraulic fitting
(6)
11 Giant button head fitting (6)
Tray assembly
12 Button head fitting (6)
Figure 2-5.-- Continued.
f. After charging pump with lubricant, close
(6) When lubricating is complete, dis-
each circulating valve by turning them all the
connect the adapter from the control valve.
way clockwise.
Wipe it clean and return it to the accessory
drawer. Rewind the hose on the reel and re-
g. Open the hose reel access door, release the
place the control valves on the bracket. Secure
reel brake (45, fig. 2-3) of the lubricant reel
the reel brake.
to be used. Unhook the control valve(s) (36,
42, 46) from the bracket, and pull the hose
b. Dispensing Gear Oil.
from the reel.
(1) Prepare the gear oil pump (28, fig.
h. Squeeze open the control valve (36, 42
or 46) by depressing the trigger and the pump
and pull out the required length of hose. Set
will automatically start filling the line and
meter pointer on the pintmeter (34) to "0".
forcing lubricant through the control valve
nozzle or adapter.
Caution: Do not try to set the pointer
beyond the "0" position.
i. Allow lubricant to flow until the line has
(3) Clean around the filler plug opening
been purged of air, and no aerated lubricant
of the unit to be filled. Remove the filler cap or
is dispensed.
plug. Insert the valve nozzle into the filler
j. Repeat this operation on the other three
opening and add the proper amount of oil.
lubricant hoses. The lubricating unit is now
(4) Clean and replace the filler plug or
ready to dispense lubricant.
cap.
2-16. Dispensing Lubricants
(5) Rewind the hose, set the reel brake
and hang the valve on the bracket.
a. Dispensing General Purpose Grease.
(1) Prepare the grease pump (27, fig.
c. Dispensing Engine Oil.
(1 Prepare the engine oil pump (26, fig.
from one of the general purpose grease reels
(2) Release the reel brake, remove the
(35) or (39) and pull out the required length
valve from the bracket, and pull out the de-
of hose.
sired amount of hose.
(3) Attach the proper adapter from the
(3) Set the meterpointer on the quart-
meter (41) to "0".
Caution: Do not try to set the pointer
(4) Clean each grease fitting of the part
beyond the "0" position.
being lubricated. Attach the adapter to it and
(4) Clean around the filler plug. Remove
squeeze the trigger.
filler plug, insert nozzle, and fill reservoir to
(5) When all the old grease has been
proper level.
forced out of the part being lubricated, release
(5) Clean and replace plug. Rewind hose,
the trigger. Disconnect the adapter and go on
set reel brake and return valve to bracket.
to the next fitting.