TM 5-4930-218-14
pins (6) through pistons. Remove pistons (7 and 10)
(7) Remove the six cap screws (63, fig. 7-1),
from connecting rods. Do not remove piston pin
Remove the cylinder block (64) with the pistons and
bearings (8) from connecting rods unless inspection
connecting rods in it, and remove gasket (65) from the
indicates that they are worn or damaged.
(b) Remove ring sets (4 and 9) taking care not
(8) Pull the assembled pistons and connecting
to expand rings more than necessary when removing
rods from the cylinder block.
from pistons.
(9) Refer to figure 7-3 and disassemble the
b. Cleaning, Inspection, and Repair.
pistons and connecting rods as follows:
NOTE
NOTE
Refer to table 7-1 for compressor repair and
Tag all parts to insure correct reassembly.
replacement standards.
(a) Remove retaining rings (5) and push piston
