1
Regulator
21
Lockwasher, 1/4 (2 req)
2
Nut, hex, regulator mtg (3 req)
22
Nut, hex, 1/4-28 (2 req)
3
Lockwasher, regulator mtg (3
23
Generator bracket
req)
24
Lockwasher, special (3 req)
4
Bond strap
25
Bond strap
5
Lockwasher, special
26
Generator rod
6
Ground screw
27
Nut, hex, special (2 req)
7
Cap screw, special
28
Electrical lead (2 req)
8
Bypass filter
29
Electrical lead (2 req)
9
Lockwasher, special (6 req)
30
Nut, hex, special (2 req)
10
Regulator support
31
Cap screw, special
11
Cap screw, regulator mtg (3
32
Lockwasher, special (2 req)
req)
33
Nut, hex, special (4 req)
12
Generator adjusting support
34
Lockwasher, special (2 req)
13
Lockwasher, special (3 req)
35
Bond strap
14
Cap screw, special (3 req)
36
Cap screw, special
15
Nut, hex, special (2 req)
37
Lockwasher, 5/16 (3 req)
16
Lockwasher, special (3 req)
38
Cap screw, special (3 req)
17
Nut, hex, special (2 req)
39
Generator body stud
18
Locking screw
40
Capacitor
19
Generator
41
Nut, hex, special
20
Cap screw, fil hd, 1/4-28 x 1 1/2 (2
req)
Figure 32. Continued.
sion, first loosen the special hex nut (17) on the end of the generator rod (26). If the belt is too loose, loosen the adjusting
support hex nut (15) below the locking screw (18) until the correct belt tension is obtained. Then tighten the upper hex nut
(15) securely. If the belt is too tight, loosen the adjusting support hex nut (15) securely. If the .belt is too tight, loosen the
adjusting support hex nut (15) above the locking screw (18) and tighten the lower hex nut (15) until correct belt tension is
obtained. Then tighten the upper hex nut (15) securely. After the proper adjustment has been obtained, tighten the
generator rod hex nut (17) securely.
b. Generator Brushes (fig. 33).
(1) Removal. Remove the cover band from around the commutator end of the generator frame, exposing the
brushes (fig. 33). Remove the screw and lockwasher that attach the brush lead to the brush holder. Swing
the brush arm up out of the way and remove the brush from the holder.
(2) Installation. Lift the brush arm (fig. 33) and install the brush in the brush holder. Then release the brush
arm so that it bears against the end of the brush. Fasten the brush pigtail lead to the brush holder with the
screw
87
