TM9-4310-396-13
a.
Disassembly. - continued
(6) Remove torsion spring (10) from relay-solenoid (7).
(7) Remove dust cover (11) of dust cover kit.
(8) Remove E-ring (12) and thrust washer set (13).
(9) Remove machine bolts (14) holding rear cover (15), and machine screws (16).
(10) Remove rear cover (15).
NOTE
There are three electrical brushes: two positive (+) brushes and one negative (-) brush.
(11) Remove electrical brushes (17) from electrical holder assembly (19).
(12) Remove electrical brushes (18) from electrical holder assembly (19).
(13) Mark position of electrical brush (18) to insure proper installation.
(14) Remove electrical holder assembly (19).
NOTE
Slide electrical coil slowly over motor armature so that it does not strike against other parts.
(15) Remove electrical coil (20) from motor armature (21).
(16) Remove motor armature (21) from gear housing assembly (22).
(17) Slide pinion stopper set (23) toward pinion.
(18) Remove pinion stopper (24).
(19) Remove pinion assembly (25) from motor armature.
5-5
