TM9-4310-396-13
c.
Assembly. - continued
(4) Insert motor armature (21) and pinion assembly (25) into gear housing assembly (22).
(5) Insert shifter fork (8) into pinion assembly (25) and insert dust seal (27) of dust cover kit into gear housing
assembly (22).
(6) Insert motor armature (21) and gear housing assembly (22) into electrical coil (20).
NOTE
Insure electrical holder assembly is position as removed.
(7) Install electrical holder assembly (19) on motor armature (21).
(8) Install electrical brushes (17 & 18) into electrical holder assembly (19).
(9) Install rear cover (15) over electrical holder assembly (19).
(10) Align screw holes in electrical holder assembly (19) with holes of rear cover (15) and install machine screws
(16).
(11) Install machine bolts (14) through rear cover (15), electrical coil (20) into gear housing assembly (22), and
tighten.
(12) Install thrust washer set (13) and E-ring (12) on rear of motor armature (21).
(13) Scrape all adhesive from rear cover (15) and dust cover (11) of dust cover kit.
(14) Apply tube adhesive to dust cover (11) of dust cover kit.
(15) Install dust cover (11) of dust cover kit on rear cover (15).
(16) Install applicable number of shims (26) on relay-solenoid (7).
(17) If removed, install torsion spring (10) into holes of relay-solenoid (7).
(18) Install relay-solenoid (7) into gear housing assembly (22).
(19) Install lock washers (6), cap screws (5) through gear housing assembly (22) into relay-solenoid (7) and
tighten.
(20) Install electrical coil wire (4) to relay-solenoid (7) and tighten nut (1).
5-9
