TM9-4310-396-13
Section V - UNIT TROUBLESHOOTING PROCEDURES
4-10 INTRODUCTION.
4-10.1 This section contains troubleshooting information for locating and correcting most of the operating
troubles which are the responsibility of Unit maintenance. Each malfunction for an individual component, unit,
or system is followed by a list of tests or inspections which will help you to determine probable causes and
corrective actions to take. You should perform the tests/inspections and corrective actions in the order listed.
4-10.2 This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective
actions. If a malfunction is not listed, or is not corrected by listed corrective actions, notify your supervisor.
4-10.3 Table 4-2 lists the common malfunctions which you may find during the operation or maintenance of
the compressor or its components. You should perform the tests/inspections and corrective actions in the order
listed.
WARNING
Fuel used in operating this compressor is explosive. Do not refuel during
operation. Avoid open flame near fuel tank filler neck. Keep fuel cap in
place except to refuel. Failure to observe this warning may result in severe
personal injury or death.
NOTE
Before you use this table, be sure you have performed all applicable operating
procedures. All procedural instructions assume that access doors are raised or
top hood assembly and access doors have been removed.
4-10.4 Refer to Unit Troubleshooting Table 4-2 for help to correct trouble in the equipment.
4-12