TM 9-4310-397-14
4-63. ENGINE OIL COOLER REPLACEMENT.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Tools:
Equipment Conditions:
Automotive Maintenance and Repair
Oil filter removed. (See para 4-62.)
Item 2, Section III, Appendix B
a.
Removal.
(1)
Remove two clamps (Figure 4-68, 1) and disconnect hoses (2). Discard clamps.
Figure 4-68. Oil Cooler
(2)
Remove nipple (3), oil cooler (4), and washer (5). Discard washer.
b.
Installation.
(1)
Install new washer (5) (item 67, appendix H), oil cooler (4), and nipple (3).
(2)
Torque nipple to 25 ft-lb (35 Nm).
(3)
Slip new clamps (1) (item 44, appendix H) over hoses (2).
(4)
Place hoses (2) on oil cooler (4) and tighten clamps (1).
(5)
Install oil filter per paragraph 4-62.
4-162