TM 9-4310-397-14CHAPTER 3OPERATOR MAINTENANCE INSTRUCTIONSSECTION I LUBRICATION INSTRUCTIONS3-1. LUBRICATIONINSTRUCTIONS.Lubrication not required at operator maintenance level, all lubrication instructions occur at unit maintenance level.SECTION II TROUBLESHOOTING PROCEDURES3-2. INTRODUCTION.a.ArrangementofProcedures.The procedures are arranged so that the most probable malfunctions appear first.The malfunction is stated first, followed by test or inspection procedure represented in logical order to isolate andidentify the fault or action required to correct the fault.b.IntroductoryInformation.(1) This table lists common malfunctions that you may find with your equipment. Perform the tests,inspections, and corrective actions in the order they appear in the table.(2)This table cannot list all the malfunctions that may occur, all the tests and inspections needed to find thefault, or all the corrective actions needed to correct the fault. If the equipment malfunction is not listed oractions listed do not correct the fault, notify your supervisor.MALFUNCTION INDEXTroubleshootingProcedureParaEngine Binds When Attempting Start ........................................................................................................ 3-3Engine Oil Pressure Does Not Register On Gauge When Starting............................................................. 3-4Engine Will Not Start In Low Temperatures............................................................................................... 3-5Engine Will Not Start In High Temperatures .............................................................................................. 3-63-1
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
