• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Section XV. MAINTENANCE OF ENGINE ELECTRICAL GROUP
Figure 4-25. Alternator assembly removal and installation.

TM-5-4310-354-14 Compressor Rotary; Air Skid Mounted; Diesel Engine 125 CFM 100 PSIG (Davey Model 6M125) Manual
Page Navigation
  104    105    106    107    108  109  110    111    112    113    114  
TM 5-4310-354-14
(3) Inspect brushes and springs for excessive
WARNING
wear, cracks, distortion, or any other
defect.
Dry cleaning solvent, P-D-680, used
to
clean
parts
is
potentially
(4) Inspect attaching hardware for distortion,
dangerous
to
personnel
and
cracks, breaks, damaged threads, or any
property.
Avoid  repeated  and
other defect.
prolonged skin contact. Do not use
near open flame or excessive heat.
c. Installation. Install the starting motor assembly
Flash point of solvent is 100 F-130 F
as shown in figure 4-24; then, connect battery cable
(38 C-59 C).
clamps on battery terminals.
b. Cleaning and Inspection.
4-38. Alternator Assembly.
(1) Clean exterior surfaces of the starting
WARNING
motor assembly with a clean cloth soaked
with solvent, Federal Specification PD-
Disconnect  battery  cable  clamps
680, Type II.  Dry thoroughly.  Blow any
from
battery
terminals
before
dust and dirt out of the inside of the
removing alternator assembly.
assembly with dry compressed air.
a. Removal.  Remove the alternator assembly as
(2) Inspect the drive assembly gear teeth for
shown in figure 4-25.
chipping, cracks, and broken teeth, or any
other defects.
4-49






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.