TM 5-4220-233-14
4-45. SHOCK ABSORBERS.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP :
Tools
Materials/Parts Appendix D
Mallet, rubber
Wiping Rag (item 13)
Socket Wrench Handle, 1/2" Drive
Cleaning Solvent (item 15)
Socket, 3/4"
Equipment Conditions
None
a.
Removal
WARNING
Prior to performing this task the Servicing Unit should be positioned on a
hard flat surface with the swivel jacks lowered, parking brakes set, and
chocks installed to provide a firm stable foundation. Failure to follow this
warning may result in serious personnel injury or equipment damage.
Figure 4-31. Replace Shock Absorbers.
(1)
Remove nut (1) and washer (2) that secures top of shock absorber (3) to chassis mounting stud (4).
(2)
Remove nut (1) and washer (2) that secures bottom of shock absorber (3) to tie plate stud (7).
(3)
Pull shock absorber (3) and washers (2) off mounting studs (4) and (7).
(4)
Repeat steps 1 through 3 for other shock absorber.
(5)
Clean and inspect mounting stud threads as prescribed in paragraphs 4-15 and 4-16.
4-70
