TM 5-4220-233-14
(3)
Pressurize brake filler and bleeder to start flow of brake fluid into surge actuator assembly (3).
(4)
Place an empty container below the bleeder fitting (4) on either brake assembly (5) to capture the fluid
that will drain when brake system is bled.
(5)
Slightly loosen bleeder fitting (4) on brake assembly (5) and allow air trapped in brake system to be
purged.
(6)
When a solid stream of fluid is flowing from bleeder fitting, tighten fitting.
(7)
Reposition container under other brake assembly and repeat steps 5 and 6.
(8)
Depressurize brake filler and bleeder and disconnect hose from surge actuator assembly (3).
(9)
Wipe excess brake fluid that may have spilled around fill port on surge actuator with a clean cloth.
(10)
Check level of brake fluid in surge actuator assembly. Add or remove fluid as necessary for fluid level to
be approximately 1/2 inch (13 mm) below opening.
(11)
Install gasket (2) and fill cap (1) onto surge actuator assembly (3).
4-75
