TM 5-4220-233-14
4-49. HANDBRAKE LEVER.
This task covers:
a.
Removal
b.
Installation
c.
Adjustment
INITIAL SETUP :
Tools
Materials/Parts Appendix D
Hammer, Ballpeen
None
Pliers, Needle Nose
Punch, Pin, 1/8
Socket Wrench Handle, 3/8" Drive
Socket, 9/16"
Equipment Conditions
Wrench, 9/16"
None
a.
Removal.
WARNING
Prior to performing this task the Servicing Unit should be positioned on a
hard flat surface with the swivel jacks lowered to provide a firm stable
foundation. Failure to follow this warning may result in serious personnel
Injury or equipment damage.
Figure 4-36. Replace Handbrake Lever.
(1) If possible release parking brake by positioning handbrake lever (1) with handle pointing up.
(2) Remove two nuts (2) and two washers (3) securing handbrake lever (1) to mounting bracket (4).
(3) Remove two screws (5), two spacers (6), four washers (3) and while holding handbrake lever (1).
(4) Remove cotter pin (7) and washer (8) and pin (9) to release handbrake lever (1) from yoke (10). Discard
cotter pin.
4-78