TM 5-4220-233-14
Figure 4-37. Install Handbrake Lever.
(1) Position handle of handbrake lever up so that lever forms a 90° angle.
(2) Rotate knob on handbrake lever (1) counterclockwise until knob cannot be rotated any further, then rotate
adjusting knob clockwise four full turns.
(3) Insert yoke (10) into handbrake lever (1) and secure with pin (9), washer (8), and a new cotter pin (7).
(4) Install two screws (5) with two spacers (6) and four washers (3) onto handbrake lever (1) and position
handbrake lever onto mounting bracket (4).
(5) Install two washers (3) and two nuts (2) to secure handbrake lever (1) to mounting bracket (4).
c.
Adjustment.
Figure 4-38. Adjust Handbrake Lever.
(1) Raise both wheels until the tires are off the ground using rear swivel jacks (1)
(2) Engage parking brakes using handbrake lever (2).
(3) Attempt to rotate both wheels. If neither wheel can be rotated proceed to step 13. If one wheel rotates and
other does not, refer to paragraph 4-50 to adjust brake cable. If both wheels rotate, proceed to next step
4-79
