OPERATING AND ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. SPECIAL TOOLS AND LUBRICANTS
and store in a clean, dry area away from heat.
Do not allow dirt, dust, water or any other for-
a. There are no special tools for equipment
eign materials to come into contact with the lu-
required to perform operator's maintenance.
bricants. Keep all lubrication equipment clean
b. The basic issue items supplied with the air
and ready for use.
compressor model OEH-34-60-ENG-1 and
Model LP-512-ENG are listed in appendix III.
b. Cleaning. Use an approved cleaning sol-
vent to wipe all surfaces clean around the point
of application before applying the lubricant.
Equipment
c. Points of Application. The points of lu.
There are no special tools or equipment re-
brication are illustrated in figure 11. Follow
quired to perform organizational maintenance.
the detailed lubrication instructions given be-
neath each lubrication point illustration indicat-
ing procedures to be followed at each point.
This section contains the current lubrication
Apply only those lubricants specified on the lu.
order shown in figure 11.
brication chart.
d. Engine on Air Compressor, Model LP-
512-ENG. Refer to TM 5-2805-206-14 for de-
ment. Keep all lubricants in closed containers
tailed engine lubrication.
